What is Panel Low Battery Trouble Condition and How To Resolve

[tyler (Tyler G)]

The Panel Low Battery trouble condition indicates the backup battery in the control panel is drained. This usually occurs after an AC power failure.

How to resolve:

1. Verify the AC power is connected and allow time for the battery to recharge. This can take up to 24 hours in most cases.
2. If it is unable to recharge, replace the system’s backup battery. For panel-specific information about recharging or replacing the panel battery, refer to the specific panel’s manual

[tyler (Tyler G)]

2GIG Edge

2GIG EDGE - Battery Replacement

2GIG EDGE - Battery Replacement The 2GIG EDGE requires a special battery pack available for purchase from the manufacturer. To replace the battery in a 2GIG EDGE: If desired, put the system in test mode with the monitoring station before proceeding. Disarm the panel. Power off the panel. Disconnect the transformer from the power outlet. Remove the four screws that secure the back panel, and then carefully remove the back cover from the panel. [Remove_screws_from_EDGE_back_plate] Ca…

2GIG Go!Control, GC2, and GC2e

2GIG Go!Control, 2GIG GC2, and GC2e - Battery Replacement

The 2GIG GoControl requires a special battery pack available for purchase from the manufacturer. 2GIG-BATT2X To replace the battery in a 2GIG GoControl: If desired, put the system in test mode with the monitoring station before proceeding. Disarm the panel. Power off the panel. Unplug the AC adapter from wall outlet Unscrew the top to remove the back cover. [battery] Disconnect the battery pack’s connector, and remove the old battery. [battery2] Plug the new battery pack’s connect…

2GIG GC3 and GC3e

2GIG GC3 and GC3e - Battery Replacement

The 2GIG GC3 and GC3e requires a special battery pack available for purchase from the manufacturer: 2GIG-BATTERY-GC3 To replace the battery in a 2GIG GC3 and GC3e: To avoid dispatch on false alarms put your system in test mode with the monitoring station before proceeding. Disarm the panel. Power off the panel. Remove AC power from the panel. Disconnect the panel from the mounting plate. Disconnect the old battery from the PCB battery connector. Ensure the new battery is properly seated in…

Qolsys IQ Panel 2 and IQ Panel 2+

Qolsys IQ Panel 2 and IQ Panel 2+- Battery Replacement

To replace the battery in a Qolsys IQ Panel 2 and IQ Panel 2+ The Qolsys IQ Panel 2 requires a special battery pack available for purchase from the manufacturer the QR0041-840 (IQ Panel 2 and 2 Plus). To avoid dispatch on false alarms put your system in test mode with the monitoring station before proceeding. Disarm the panel. Power down the panel Go to Advanced Settings, enter the Installer/Dealer/Master code, then tap Power Down. Once powered down, disconnect AC power from the wall outlet…

Qolsys IQ Panel 4

Qolsys IQ Panel 4 - Battery Replacement

To replace the battery in a Qolsys IQ Panel 4 The Qolsys IQ Panel 4 requires a special battery pack available for purchase from the manufacturer, the IQ Battery QR0083-840 To avoid dispatch on false alarms put your system in test mode with the monitoring station before proceeding. Disarm the panel. Power down the panel. Go to Advanced Settings, enter the Installer/Dealer/Master code, then tap Power Down. Once powered down, remove AC power from the panel. Once the panel is powered down, un…