Surety Support Forum

How to Install an Alarm.com VDB770

alarmdotcom, cameras, videodoorbell

tyler (Tyler) August 19, 2022, 7:08pm 7

Troubleshooting

ADC-VDB770 LED Troubleshooting Guide How To

Below are the various potential LED conditions and what they indicate on your ADC-VDB770. You will see a variety of these during normal setup and operation: Solid red - No local or Internet connection Blinking red - Power on, camera booting Solid green - Connected to Alarm.com Blinking green - Local network connection Double-blinking blue - Unable to ring indoor chime Blinking blue - WPS mode (press and hold button for 30-35s) Blinking white - Wi-Fi Access point mode (press …

How To Factory Reset an Alarm.com VDB770 Video Doorbell Camera How To

Factory reset an ADC-VDB770 to its default settings Resetting a video device to its factory defaults removes all programming from the device. Important : Wait at least two minutes for the video device to power on fully before performing the following procedure. The factory reset might fail if the device is still powering on. Reset procedure Press and hold the doorbell button for at least 45 seconds until the LED starts blinking red and green. Wait for the device to reboot. Reset button loc…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled