Garage door status/operation is buggy on latest update

[nicholas]

At this point, I recommend removing and then reconnecting the device to your system.

It looks like you’re using a Linear Z-Wave Garage Controller. Is that correct?

Steps for removing and re-adding the device from your system can be found in these guides:

How To Setup a Linear Z-Wave Garage Controller

To enroll a Linear Z-Wave Garage Controller into a Z-Wave Network: Put the Z-Wave controller into Add Mode. Press and release the link button on the GD00Z. Verify that the GD00Z was recognized by the Z-Wave controller. To delete a Linear Z-Wave Garage Controller from a Z-Wave Network: Put the Z-Wave controller into Delete Mode. Press and release the link button on the GD00Z-4. Verify that the GD00Z was excluded by the Z-Wave controller. To factory reset a Linear Z-Wave Garage Controller…

How To Add/Remove Z-wave device and run a Network Rediscovery with Qolsys IQ Panel 2/2+ and IQ Panel 4

This guide covers the various Z-Wave pairing processes with the Qolsys IQ Panel 2/2+ and the IQ Panel 4 1. How to Remove a Z-Wave device from the parent network. An often overlooked step in the process. In order to remove a device from its parent network. Always do this first when adding a device, because it may still have network data saved within its Z-wave radio and this needs to be cleared before it can be added to a new panel. Navigate to the Settings Tray and click Settings Click Advanc…