Alarm.com Smart Thermostat ADC-T3000

[tyler (Tyler G)]

Installation

Installation and Operation ADC-T3000

Alarm.com Smart Thermostat ADC-T3000 - Installation and Operation

Troubleshooting Heating or cooling does not turn on when the set point is above or below the room temperature To prevent damaging the compressor, the thermostat inserts a delay when cycling the compressor. If the system should be on and it’s not, then change the set point to be 2 degrees beyond the current set point and wait 5 minutes to see if the system turns on. If not, contact a local HVAC professional. Heat pump is “cooling when it should be heating” or “heating when it should be cooling” S…

Pair ADC-T3000 to a Z-Wave Network

How To Pair an Alarm.com Smart Thermostat ADC-T3000 to a Z-Wave Network

This guide covers how to get an Alarm.com Smart Thermostat ADC-T3000 into Z-Wave inclusion mode. If you are looking for how to pair the Alarm.com T2000, see this guide here. Should you need to know how to put your panel into Z-Wave pairing mode, you can find panel specific information below: 2GIG Go!Control, GC2 2GIG GC3 Qolsys IQ Panel 2/2+ ADC T3000 [ADCT3000] Add to the Z-Wave network Put the Z-Wave controller into ADD mode. Refer to the controller documentation for more information. P…

Replace Batteries in ADC-T3000

Replace the Batteries on an ADC-T3000 Smart Thermostat

The Alarm.com Smart Thermostat (ADC-T3000) can be powered by two AAA Alkaline batteries. Considerations: If there are no batteries inserted, and the thermostat is running off solely of AC power, the thermostat will report a low battery (indicated by a caution sign and LOW BATTERY flashing on the display). Always replace the batteries as soon as they have low battery levels. If the batteries drain, the thermostat could leave the HVAC system on or off, overheating or freezing the home. If the th…