Alarm.com Smart Thermostat ADC-T2000

[tyler (Tyler G)]

How to Install Alarm.com Smart Thermostat ADC-T2000

Alarm.com Smart Thermostat ADC-T2000 - Installation Guide

Troubleshooting Heating or cooling doesn’t turn on when the set point is above or below the room temperature To prevent damaging the compressor, the thermostat inserts a delay when cycling the compressor. If the system should be on and it’s not, then change the set point to be 2 degrees beyond the current set point and wait 5 minutes to see if the system turns on. If not, contact a local HVAC professional. Heat pump is “Cooling when it should be heating” or “Heating when it should be cooling” S…

How to pair ADC-T2000 to Z-Wave Network

How To Pair an Alarm.com Smart Thermostat ADC-T2000 to a Z-Wave Network

This guide covers how to get an Alarm.com Smart Thermostat ADC-T2000 into Z-Wave inclusion mode. If you are looking for how to pair the Alarm.com T3000, see this guide here. Should you need to know how to put your panel into Z-Wave pairing mode, you can find panel specific information below: 2GIG Go!Control, GC2 2GIG GC3 Qolsys IQ Panel 2/2+ ADC T2000 [ADCT2000] Connect the ADC T2000 thermostat to the system Put the thermostat in OFF mode (i.e. no mode icons are lit). Put the Z-Wav…

How to replace the batteries on a ADC-T2000

Alarm.com Smart Thermostat ADC-T2000 - Battery Replacement

The Alarm.com Smart Thermostat (ADC-T2000) can be powered by four AA Alkaline batteries. Considerations: If there are no batteries inserted, and the thermostat is running off solely of AC power, the thermostat will report a low battery (indicated by LOW then BATT flashing on the display). Low Battery alerts will still occur in thermostats running off AC Power with backup batteries inserted. Replace the backup batteries to clear the alert. Always replace the batteries as soon as you have low ba…