Qolsys IQ Panel 4 and IQ PowerG Smart Switch Issues

[jwcsurety (Jason)]

Support for the PowerG Smart Switch and other PowerG automation devices was added in 4.4.0 firmware.

4.4.1 should be applied. See the instructions here:

Qolsys IQ Panel 4 Firmware Release Information

IQ PANEL 4/IQ4 HUB/IQ4 NS - 4.4.1 SOFTWARE UPDATE Fixes/Improvements: • Added a critical update relating to recovery of cellular connectivity in certain cases where it could become disconnected from the network – this firmware is for all IQ Panel 4, IQ4 Hub, and IQ4 NS systems. Panels that are not upgraded to 4.4.1 may have difficulty reconnecting to the cellular network, if the cellular interface experiences a disconnection Update Instructions: Compatibility Note: Your IQ Panel must be on …

After updating firmware you will likely need to relearn the switches.