Migrating from 2GIG GC2 to Qolsys IQ Panel 2+

If they only have one main panel downstairs and there is intrusion event, is there a way to send out a duress signal from the iPhone ADC app or a person will need to go downstairs?

You can add the In-App Panel Panic feature allowing you to set off panics from the app.

I had a false alarm event recently and was able to cancel it via ADC app without the signal going to monitoring station and it showed up as a pending alarm. I checked my IQ panel and Normal Delay is set at 30sec.

Normal Delay is a setting for Entry Exit zones determining the Entry Delay length.

“Pending Alarm” is referencing Dialer Delay. That is a different setting with a different function.

Read about dialer delay here.

Windows should not be entry exit zones. You cannot have different entry delays for away and stay.

In my ADC app, under users, it shows 2 separate users: Duress Code and Duress… any reason to have both? Picture below

There is only one Duress code on the IQ panel, I’m thinking this may be an error related to swapping panels if you have two showing up.

With the old 2Gig panel, the top 2 buttons when pressed together would send duress code… how do I program it with the IQ panel?

The Aux button on the fob is used for the panic activation on the IQ Panel 2+ I believe. There is no way to adjust that as far as I know.