Can you also share what needs to be changed to remove the signal delay to the alarm company when the alarm goes off?
Dialer, or Transmission Delay, can be adjusted. Steps on how to do so can be found below:
My panel at home is powering down randomly. I have to push the button on the side and it will boot up. The battery is fully charged.
To trouble shoot, turn the panel off, Settings > Advanced Settings > Power Down.
- Unplug the power supply from the wall.
- Open the panel disconnect the internal battery
- Check to make sure the power supply is wired correctly both at the panel and at the power supply itself.
- After checking, reboot the panel, battery first, then power supply.
Is the included power supply being used? What is the printed voltage?
Have any changes been made to the cable run? If so, what is the length of the run and the gauge of wire in use (should be printed on the wire).