There is a known issue which can cause the panel to mishandle Interior Follower zone types during entry delay. If you use motion detectors in areas between your entry point and the panel, do not use this update, or program motion detectors as zone type (10) Interior with Delay.
New Features:
AT&T LTE 4G, 6 digit pin, and support of additional eSeries sensors
Added support for the AT&T LTE 4G on Alarm.com [Model # 2GIG-LTEA-A-GC3]
Added support for additional sensors:
2058 – eSeries Smoke Detector (USA)
2061 – eSeries Tilt Sensor
2065 – eSeries Flood Sensor
2067 – eSeries Repeater
2069 – eSeries FireFighter SMKT/CO Listener
2070 – eSeries Water Sensor
2860 – eSeries CO Detector (USA)
2865 – eSeries Outdoor Door/Window Sensor
2864 – eSeries Panic
2873 – eSeries Takeover Module
Support for 6 digit pin codes:
Installer Question #71 added “Security pin code length”
Default: 4 Digits
Option: 6 Digits
When switching to 6 digit codes all existing codes will be appended with “11”
6 Digit Master Code default: 111111
6 Digit Installer Code default: 156111
Console Restore will not restore Q71. If panel is set for 6-digit pin and reset the “Console” the panel will
remain set to 6-digit pin. Q71 will reset to default of 4-digit if “Users” are reset to default.
Enhancements and Defect Resolutions:
- Resolved panel intermittent lock up of SP1 keypads
- Resolved Alarm buttons on partitions screen does not respond after the panel is disarmed
- Resolved any trouble associated with zones removed from the panel would not clear