Alarm.com Remote Temperature Sensor

[tyler (Tyler G)]

Adding the Temperature Sensor to the Z-Wave Network

How do I enroll the Alarm.com Temperature Sensor?

The ADC-S2000-T-RB Remote Temperature Sensor (RTS) is slightly different than other Z-Wave devices in that it doesn’t respond to network rediscoveries, and must be learned in after all other Z-wave devices. To enroll the Remote Temperature Sensor (RTS) into a Z-Wave network: Enroll all of your other Z-Wave devices in the network. Verify the panel and all Z-Wave devices are in their final location. Run a network rediscovery. This can take several minutes to complete, depending on how many Z-Wav…

More information on enrolling Z-Wave devices into your Alarm.com compatible panel and setting up a Z-Wave Network can be found in the below guide:

How To Set Up a Z-Wave Network

This guide is a reference on how to pair z-wave devices to your Z-wave compatible alarm panel. If you would like to increase your current Z-Wave mesh network range and quality, see this post here. One of the biggest rewards of owning an alarm system and utilizing Alarm.com is the ability to create your own smart-home network of Z-wave devices. There is, however, a slight learning curve to the installation and troubleshooting when it comes to Z-Wave. Required steps unique to Z-wave (as oppos…