The price is compatible to the tilt
Typo, I meant “comparable”
Can I return these then and do what the other poster recommended?
The DW10 comes with wire leads, plug it in, and then connect the wires to the wires of the overhead garage door reed switch. Tape them off (like you see in pics above). You will need a drill/drill bit. Just install it like you see it.
You will not be installing the DW10 magnet, so save it after you use it to learn serial. They come in handy.
Programming DW10 loop1:
Hit logo at bottom right of screen
Enter installer code
System configuration
Right arrow to blank sensor location
Down arrow
**(02) exit/entry 2
Down arrow
(0862) dw10
Down arrow
Learn serial (or hit shift then learn)
Pull magnet away from switch to get serial programmed
Down arrow
(0) new equip
Down arrow
*Loop (1) 1
Down arrow
(0) disable dialer delay
Down arrow
Voice descriptor (“insert”, enter code…example ‘Garage Door’ code is “101” and “058” for all codes see: Descriptor codes)
Down arrow
(1) report enabled
Down arrow
(1) supervised enabled
Down arrow
(01) voice only
Skip
End
Exit