Yes, that’s perfect.
Ok, your module responded to a time request sent by ADC earlier with the accurate time for your area. The ADC module has the correct time.
The issue looks like it is with the panel or panel - module communication.
Can you please unplug your panel’s transformer from the outlet it is plugged into, then open the panel and disconnect the battery.
Leave the panel powered off completely for 5 minutes.
Then plug in the battery, close up the panel, and plug in the transformer in its outlet again.
After booting up, allow a couple minutes, any change?
If not, can you try to manually set the time under Settings > Master Code > Date/Time? Does it remain correct after manually setting it?