Smart Water Valve+Meter ADC-SWM150 - Installation Guide

How To
, ,
4

To add the Smart Water Valve+Meter to the Z-Wave network:

Important: For best results, it is recommended to bring the Z-Wave controller into the area where the Smart Water Valve+Meter is installed during enrollment.

As a SmartStart device:

It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).

As an S2 device:

If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.

As an S0 device:

  1. Put the Z-Wave controller into add mode.
  2. Press the Network button on the side of the Smart Water Valve+Meter control unit to begin the Add process. The Network LED on the control unit will begin flashing.
  3. After the Smart Water Valve is successfully added, the network light on the Smart Water Valve will turn solid. If the Network LED is not illuminated after the add process, repeat steps 1 and 2.