Unfortunately, I still have issues. Since updating to 4.6.1, my panel is not stable and others are reporting similar issues.
Over the weekend, the panel got slow again and I rebooted it. I was adding new sensors, but that never triggered issues before I upgraded to 4.6.1.
Today:
- I initiated an Arm-AWAY at 6:14 PM.
- Within 15 seconds, I exited the house and closed the door.
- At 6:16PM, the panel recorded the door open (about 2 minutes after I opened the door) and triggered an alarm.
- The panel crashed and reported Panel-Power Up at 6:18.
- I struggled to cancel the alarm in the app, probably because the panel was rebooting.
- Around 8:35 I powered down the panel. I took it off the wall. I unplugged the battery. I waited until 9:00 to reconnect everything. The input voltage is 7.14vDC.
Please escalate this issue to get a working patch. While users cannot downgrade firmware, Qolsys can issue a new version that brings up back to a stable system. @vidail @tyler Surety needs to advocate for us – as a DIY model, you are our leverage. Surety advides me to install 4.6.1, please help get it fixed.
I have seen other issues reported, so I am sure it is not unique to my system:
https://www.reddit.com/r/alarmdotcom/comments/1r3tzku/iq4_panel/