PG9905 temp non-reporting - not showing in app or alarm.com

Support
1

I have two PG9905 temperature sensors that work fine in freeze mode (they trigger an alarm and app notification). They both show up in the app (I can edit the device name) and on alarm.com under “Detectors”. However, when I set them to temp non-reporting I don’t get a temperature card on the app or alarm.com, so I can’t see the actual values.

Per a previous thread (PG9905 Pairing - #6 by jbecher1), I think this issue has occurred in the past. Was it resolved?

2

Please disregard - it just took a bit for the sensor group to change and start reporting.

3

There can be a short delay in the panel syncing changes and ADC displaying the change. Logging out and logging into Alarm.com may be needed in some cases.