Status LED guide
| LED pattern | Description |
|---|---|
| LED OFF | Off |
| LED Sold Green | Connected to Alarm.com |
| LED Blinking Green | Local Network Connection |
| LED Blinking Red and Green | Reverting to Factory Default Settings |
| LED Blinking Red | Power On, Camera Booting |
| LED Solid Red | No Local or Internet Connection |
| Blinking Blue | WPS Mode |
| Blinking White | AP Mode |
Troubleshooting
- If you have issues connecting the camera to the account, power cycle the camera and try again.
- If issues persist, press and hold the Reset button
located on the bottom of the camera until the LED is blinking green and red (about 15 seconds), then release the button. The camera will reboot with factory default settings.
Important : If the camera was previously installed to an Alarm.com account, it will need to be deleted before it can be installed again.