HomeSeer and Qolsys

Support
,
10

That’s too easy, how didn’t I think of that.

Walkthrough to setup HomeSeer HS4 with a Qolsys IQ2+ Panel

  1. Setup all your devices in Homeseer (remove them from the IQ2 first!)
  2. In Homeseer Z-Wave Controller Management, execute the Send Network Information to another Controller command with the HS Z-Wave stick close to the IQ panel
  3. On the IQ panel with Advanced Z-Wave settings enabled, touch “Add/Remove Controller” under Dealer - Install - Z-Wave devices
  4. Wait for the operation to complete
  5. Check status of locks and lights
  6. If you have issues, repeat steps 2 to 5 - if it still doesn’t work, get the HS Z-Wave interface as close as possible (within 3 feet) of the IQ panel and try again
  7. You should have full control of all Z-Wave devices both from HS4 and the IQ2+ panel/ADC
  8. To ensure status gets populated for the IQ panel and on ADC, click on your device in HS4, then Z-Wave, then Manage
  9. Under Associations, click Update, then drop down to Association Group 2, add your IQ panel, then Add Association
  10. Make sure to optimize then backup your network in HS4.
1 Like