Funny you should ask. I have three Zen14’s, all for outside holiday lights.
This is all new, but I noticed last night during the shut off schedule, it didn’t seem to fire the ‘turn off’ command on all of the outlets (as per the activity log) HOWEVER all power was off on the units!! When I looked in alarm.com, certain outlets appeared as powered on, but they really were off. ( I did not check the IQ4 panel for status at that time.)
Right now, these same lights came on at sunset. I can see the schedule (per the activity log) didn’t fire on all the outlets again, but it missed DIFFERENT outlets than it missed last night (?)? However, I just went out and checked, and all outlets have power, even though if I look in Alarm.com, it shows one outlets as being powered off. When I look at that same outlet in the IQ4 panel, it shows the correct status as being powered on. Here are screenshots. It is Driveway Holiday Right (60.1)
On in Panel (and real life):
Off in Alarm.com:
PS: If I manually command the outlets from Alarm.com, they do turn on/off independently as they should. It just seems that the status when a schedule fires is not completely accurate?
PPS: Manual commands from the IQ Panel work as well, but they always did. 