So, we’re not able to replicate this, and going back through this thread your original doorbell wasn’t on 3052 when you reported this. It was on a previous firmware. Likely 3050. You updated the firmware during the course of troubleshooting.
**As I stated few post back. I purchase a use one from ebay that was on 3050 we are not talking about same doorbell anylonger. BEFORE update to 3052 picture was perfect. **
I don’t think you are seeing firmware related causes here. 3052 only had changes regarding motion detection.
Motion detection is OFF
I know we have gone over this previously in the thread, but I have to point out again that this doorbell is currently reporting bad wireless connection quality.
Objectively, the signal quality above 90% is what we are looking for for best quality. Your Skybell is reporting 78-83%.
Yes we did.Sky bell is know for not reading signal correct. my unifi network shows signal strength to each device. door bell is between 99% to 100% all the time. and its few feet away from access point. - again before firmware update picture was fine.
There is an absence of other potential causes that I can see. The upload speed you mentioned previously is well above what is required.
The wifi connection quality requirements on the Skybell are higher than other cams. This can catch users off guard and has been a point of frustration with Skybell models. Brick is very good at attenuating the signal.
Again my network provide real live signal strength - sky bell meter is incorrect. I can put my access point foot away from it and it will not change. thrust me I try. and again before update picture was fine.
The future ADC model is coming with dual antennae for better wifi connection.
Finally !!! cant wait
One thing I would like to test is the visible quality difference between the three compression levels.
I be happy to do that when i get home and post results, but again this was not a problem with 3050
Can you submit an image for each showing highest settings, medium settings, and lowest settings?
Will do but i don’t think there is going to be any difference. I can also submit picture form 3050 and 3052