Deleting a Zwave Device

[jwcsurety (Jason)]

There are no nodes above ID6.

Steps for enrolling a device are found below:

How to Manage Z-Wave devices on a SEM-DSC PowerSeries

The Z-Wave controller on the SEM-DSC PowerSeries is built into the Alarm.com cellular module (SEM), so swapping the panel requires no action in regards to Z-Wave, while swapping the module requires the deletion and addition of any existing Z-Wave devices. It is recommended to enroll no more than 60 total Z-Wave devices and up to 5 thermostats to ensure network stability. Z-Wave network stability depends on many factors, including the number of enrolled devices, network layout, environmental int…

For a lock, a couple general considerations:

1. The lock should be within about 6 feet of the SEM when learning it in. Bring the lock to the SEM to pair it for best results.
2. Referenced on the how to page above, you may need to run the Delete Device steps on a Z-wave device before successfully adding it. Even if purchased new, Z-wave devices are sometimes tested by the factory, and retain parent network data. This data must be deleted before the device can be enrolled in any other Z-wave network. Any controller, including the SEM, can erase this data by way of the standard exclusion process.