2GIG-BRDG1-900

Support
,
1

Received and installed the Bridge. On my network, configured in panel and seen over 900Mhz. Anything else I need to do for SuretyDIY or Alarm.com in the configuration? I did not enter anything in any of the 8 ports available. I assume this is available for Port Matching to pass through back into my network.

Can you confirm?

After posting, I went back and looked at the GC2 Panel config. I now see a forwarded port and IP address.

2

Here is another forum thread concerning the setup of the Bridge.

It specifically covers some port # questions. Generally you will leave these at default values.

I see ping acknowledgement over broadband, should be good to go.