Zwave, WIFI and other protocols integration with iq4

[tyler (Tyler G)]

So why i’m here, well previously i seen people using other controllers and integrating that in to alarm.com or as secondary controller. I always use the panel because i like the integration in to one app and how everything works together when it works. Does anyone has any recommendations on what to use ?

This is not supported by the IQ Panel 4. Qolsys used to support this a few years ago on earlier versions of the IQ Panel 2, but that is no longer the case. You’ll find a variety of posts on this topic here on the forum

Information specific to the IQ Panel 4 can be found in this thread:

IQ Panel 4 not connecting to Smartthings hub as a secondary Z-wave controller

I have tried again to join the IQ Panel 4 to Smartthings after the 4.0.1 update and still have the same problem. I have used the steps on the link you have provided as well as several other similar sites. That is how I was able to even see the DSK pin code in the first place. Again, the problem is Smartthings does not allow you to initiate a joining / pairing by entering a DSK pin code alone. That is a step after the initial pairing, handshake takes place to facilitate a secure connection. Sma…

IOr is there a way to turn off secure pairing on the panel? I know on iq2 i was sens a zwave daughter board that did not have secured protocol on…

Z-Wave daughtercard is non-removable on the IQ Panel 4. S2 S0 request cannot be disabled on the panel, more information on S0 and S2 can be found on page 98 of the IQ Panel 4 manual.