Image Sensor settings

Is it possible to make it so that when an alarm occurs I can take photos every few seconds for the next five minutes with my Image Sensor? It would be nice to allow for longer periods of time to take a series of photos after certain events if it isn’t already possible.


During an alarm state, the image sensor is actually programmed by default to continue taking images during the alarm. Each image sensors will continue to take images until the system is disarmed or it has taken 30 images, whichever comes first.

Unlike when the panel is disarmed, there is no idle delay required for the image sensor to detect motion while in an alarm condition. After the panel is disarmed, the image sensor will not be able to take another image for at least 3 minutes following the disarm command.