Surety Support Forum

Alarm.com Smart Thermostat HD ADC-T40K-HD

zwave, thermostats, alarmdotcom

tyler (Tyler G) January 5, 2024, 9:23pm 4

How to Install the ADC-T40K-HD

Alarm.com Smart Thermostat HD ADC-T40K-HD - Installation Guide How To

Test the system Caution: Do not test the cool mode during cold weather. Wait for mild weather to fully test the system. After successfully installing and setting up your new Smart Thermostat HD, please test the Smart Thermostat HD and HVAC system. If the Smart Thermostat HD will control a heating system, test the heating system by changing the mode to HEAT and adjusting the setpoint to be higher than the current room temperature. Verify the heating system turns on and that the room is starting…

How to Pair the ADC-T40K-HD to a Z-Wave Network

How to Pair an Alarm.com Smart Thermostat HD ADC-T40K-HD to the Z-Wave Network How To

Add the Smart Thermostat HD from a Z-Wave network Place the Z-Wave controller into Add Mode. Tap MENU on the Display. Tap Network Settings. Tap Z-Wave Connection. Tap Add to Network. In Network Configuration, tap Add. Note: The Add button is only displayed if the Smart Thermostat HD is not currently enrolled to a Z-Wave network. A message will appear to indicate whether the device was enrolled. Delete the Smart Thermostat HD from a Z-Wave network Place the Z-Wave controller into Delete Mod…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled