Alarm.com Smart Thermostat ADC-T3000 - Installation and Operation

How To
, ,
6

Operation

Waking the device

  1. Press any button to wake the thermostat up.
  2. After waking, the display will show the current mode, room temperature, and setpoint.

Changing the mode and setpoint

  1. Press the MINUS button.
  2. Select MODE.
    • The modes are HEAT, COOL, AUTO, EMER, and OFF.
    • The thermostat will only show the modes that are available based on the system configuration.
    • When in EMER mode, the thermostat will flash EMER when the display wakes up, and it will show HEAT at the top of the screen. Changing the mode will leave EMER mode.
  3. Select the desired mode.
  4. Once in the desired mode, press the UP and DOWN buttons to adjust the desired setpoint.
    • In AUTO mode when the system is idle, the screen will display AUTO. The thermostat will display HEATING when calling for heat and COOLING when calling for cool.

Changing the fan mode

  1. Press the MINUS button.
  2. Select the FAN MODE option.
    • The fan modes are AUTO, ON, and CIRCULATE. The thermostat will only show the fan modes if it has been configured to control a fan.
    • AUTO mode will automatically turn the fan on when your system is either heating or cooling.
    • CIRCULATE will turn the fan on for 15 minutes every hour by default. The duration for CIRCULATE can be configured from the online account.

Changing the batteries